RE: pcmci

From: Kautzmann Gerd ([email protected])
Date: Thu Sep 26 2002 - 15:37:51 CEST

• Next message: Stephen Isard: "Re: eccoci + xprobe"
• Previous message: Philippe Raufast: "Re: Re: SVGA X Server setup"
• Maybe in reply to: hazz: "pcmci"
• Next in thread: Cenobyte: "Re: pcmci"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

with kind regards / mit freundlichen Grüssen

Gerd Kautzmann

--
/**************************\
*  Gerd Kautzmann
*  Software Entwicklung
*  Baumer Ident GmbH
*  Hertzstr. 10
*  D-69469 Weinheim
*  +49 (0) 6201 / 9957 15
\**************************/ 
> -----Original Message-----
> From: Vesa-Pekka Palmu [mailto:[email protected]]
> Sent: Thursday, September 26, 2002 3:17 PM
> To: [email protected]
> Subject: RE: pcmci
> 
> 
> > AFAIk there are WWW Pages that show what cards are 
> compatible to linux. I
> > don't know if there are any pcmcia drivers in mulinux, but 
> never buy a card
> > that is incompatible.
> 
> D-link is alteast one company thet keeps it's NICs linux 
> compatible, but their 
> procudts tend to be on the expensive side, but they give out lifetime 
> quarantees :)
Sounds nice, the first Ethernet card on my Laptop went defective cause one
of the connectors broke is still think about soldering the Adaptor directly
to the pcmcia card.
Now I bought another 'under 35 Euro' Card.
cu Gerd
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]

• Next message: Stephen Isard: "Re: eccoci + xprobe"
• Previous message: Philippe Raufast: "Re: Re: SVGA X Server setup"
• Maybe in reply to: hazz: "pcmci"
• Next in thread: Cenobyte: "Re: pcmci"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:22 CET