From: Anonymous User ([email protected])
Date: Wed Sep 18 2002 - 12:48:25 CEST
I ve tried to install a linux network whith mulinux as server.
The Client is a pentium 3 with win98 on it.
I ve done everything like explained in a linux newspaper.
>From there I got the explanations. I did setup -f Network and wrote the
IP ADDress and the Broadcast adress and the Networkadress and last but
not least the Netmask.
eth0 is my interface.
I took the hostname and the Domain which Mulinux told me to take.
But after installation I was not able to reach my Windows Client whith
the ping command.Nor was I able to reach the server from the client.
Where Can I enter the workgroup. Do I need a Workgroup?
When I entered Ifconfig I was not able to see my networkcard.
I only saw the lo device?
Is that the reason?
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:22 CET