From: liquidlizard ([email protected])
Date: Sun Dec 16 2001 - 20:27:39 CET
-----Original Message-----
From: liquidlizard [mailto:[email protected]]
Sent: Sunday, December 16, 2001 6:26 PM
To: [email protected]
Subject: RE: rtl8139 problem
-----Original Message-----
From: Peter Andersen [mailto:[email protected]]
Sent: Sunday, December 16, 2001 7:58 PM
To: [email protected]
Subject: Re: rtl8139 problem
liquidlizard wrote:
>
> Hello,
> I am having a problem with the rtl8139 network card. When I probe the
> machine it returns
>
> realtek rtl8139
> so I enter the name rtl8139
> I go through all the other setup questions
> then it tells me there is a problem with the card
> I know the card works just fine because this is the same box I run Freesco
> on. I am trying to convert to MULINUX
> Kenny
How is the hardware for the RTL8139 setup ?. Is it plug and play ? If
yes then remember that you may not tell mulinux irq and add. I use the
rtl 8139 on a sbc and it run OK just as a plug and play.
/Peter Andersen
I had it setup 2 ways
1. Same as in Freesco I/0 0x6000 irq 12 didn't work (works in Freesco)
2. I just entered 0 for i/o and irq didn't work
it is in a PCI slot and Plug and play is enabled in bios
I tried the NE2000 and it didn't work
I am stuck
MULINUX cant find my NIC and Smoothwall cant find my serial modem
and they both work great in freesco
IM CONFUSED!!!!!! ARGHHHH : )
\Kenny
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:21 CET