From: Fam. Coumans ([email protected])
Date: Sun Apr 22 2001 - 12:23:16 CEST
I keep stuck at the 'LI'-message when booting from harddisk.
The clone-process and the liloconfig-part of it, put the 'lilo.conf' at the
/tmp directory. It has to be on the '/mnt/etc', so I put it there. The
lilo.conf looks good to me.
Running 'lilo -r /mnt' to install the maps gives a message which indicates
to many symbolic links.
So, I made a /boot with a copy of the files in /mnt/startup/boot, except the
map-file.
Running lilo installs gives the message 'muLinux installed', a new map is to
be found at /mnt/boot, which is ok.
Rebooting still stops at 'LI'.
What next?
----- Original Message -----
From: Michele Andreoli <[email protected]>
To: <[email protected]>
Sent: Wednesday, April 18, 2001 11:23 AM
Subject: Re: Cloning to harddisk, EXT2
> On Tue, Apr 17, 2001 at 07:24:50PM +0200, Fam. Coumans nicely wrote:
> > First of all, I want to know if the aim of the clone-command is to leave
me with a system that will reboot from hda1 without any manual editting
config-files. If yes, I will do the whole process over to see it there are
any error-messages I overlooked. If not, what actions have to take place to
get to that situation (my experience with the other floppy-based
distribution learned I did have to edit lilo-configuration file, and run
lilo to install a new map)?
> >
>
> Usually, "clone" also install LILO. Otherwise, try with "liloconfig".
> Michele
>
>
> --
> In summing up, I wish I had some kind of affirmative message to leave
> you with, I don't. Would you take two negative messages? - Woody Allen
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:18 CET