RE: ttyS0, ttyS1, ttyS2's problem

From: Bob Romprey ([email protected])
Date: Sat Jan 27 2001 - 03:11:15 CET

('binary' encoding is not supported, stored as-is) Did you specify
ttyS0
or
/dev/ttyS0
???
/dev/ttyS0 is actually the path to the location/name of the file that's used for "com1" under dos
As linux treats devices as just another file to be read or written to, you must specify /dev/ttyS0 to tell configuration that your mouse is on com1 (dos)
Hope this helps

winsor

>Reply-To: [email protected]
>Date: 25 Jan 2001 23:42:05 -0800
>To: [email protected]
>From: [email protected]
>Subject: ttyS0, ttyS1, ttyS2's problem
>
>dear all,
>
>I'm still not understand about this problem, when I was triying to configure port ( setup -f port ), then there was a problem like this :
>
>ttyS0 : no such device
>ttyS1 : no such device
>
>thanks,
>arnold
>
>
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: [email protected]
>For additional commands, e-mail: [email protected]

------------------------------------------------------------
Visit the world's greatest site at http://www.farts.com and listen to the fart
of the day. Also, get your very own farts.com E-mail account. FREE!!!!!

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]

This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:18 CET