From: Jef Knoors ([email protected])
Date: Mon Jul 17 2000 - 08:53:37 CEST
On 17 Jul 2000, at 14:55, Robert Heezeman wrote:
> I am trying to configure my network - but mulinux Setup doesn't like it.
>
>
> I have a Realtek RTL8139 PCI adaptor (embedded)
> I tried to use ne2k-pci selection with:
> io=0x0e000 irq=0xb
> because these are pre-set in my hardware.
>
> On boot of modules I get no adaptor found io=0xNNN
>
> I looked inside network.cnf and it had recorded 0x0e000 and the irq=0xb
>
> Is there a RTL8139 driver for MULINUX ???????
>
> Is there anything I can do ??
>
> Thycon Confidential Information
>
>
I have the same card, in case of trouble try to disable com1-com2
witch will giive you 2 more free IRQ's. Plug & Pray.
Jef
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:15 CET