From: Michele Andreoli ([email protected])
Date: Wed Apr 05 2000 - 22:03:14 CEST
On Wed, Apr 05, 2000 at 08:34:13PM +0200, Hans-Jürgen nicely wrote:
> Does anyone use Mulinux as Gateway and can tell me how two configure
> multiple ethernet cards?
> I have two ne2000 clones and later i will have one ne2000 and one 3Com card.
>
> What i tried:
> use setup -f eth and choosed ne as module and put io=240,300 irq=3,10 as
> parameters.
> the two cards were detected but i could not configure the second card with
> ifconfig and route cause the device eth1 was not found.
>
Configure card-1 with standard "setup network", and card-2 with
"setup local". A true support for multiple NIC card are under
development ( a TODO)
Michele
-- I'd like to conclude with a positive statement, but I can't remember any. Would two negative ones do? -- Woody Allen --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET