From: Hans-Jürgen ([email protected])
Date: Wed Apr 05 2000 - 20:34:13 CEST
Does anyone use Mulinux as Gateway and can tell me how two configure
multiple ethernet cards?
I have two ne2000 clones and later i will have one ne2000 and one 3Com card.
What i tried:
use setup -f eth and choosed ne as module and put io=240,300 irq=3,10 as
parameters.
the two cards were detected but i could not configure the second card with
ifconfig and route cause the device eth1 was not found.
putted
alias ne eht0
alias ne eth1
option ne io=240,300 irq=3,10
into modules.conf.
It had no effect. The cards were not detected and not configurable
tried append in lilo.conf -> no effect
Anyone who uses Mulinux as Gateway can you tell me what you did and send me
your configfile which lets you use your ethernet cards under Mulinux?
mfg, Hans-Jürgen
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET